Module Connections

The benchwork on my layout is made up of three modules, which makes it necessary to have a way to connect and align the modules. To support the modules, I first attached a one by two inch board along the ends of the modules with legs. The picture below shows the module ends after the lower board was attached.

The corner module was then placed on the board. After that, I drilled holes into both module end boards. These holes then had three inch long bolts inserted into them to align the modules, as shown in the photo below.

I then screwed two small screws into the module connections to make sure the modules were secure.

The picture above shows the module ends with the screws in place.

This marks the end of benchwork on the scenic portion of the layout.